ALLEN GWYNNES Pump

STANDARD FEATURES

The ‘NIMBUS’ pumps – The single stage end-suction centrifugal type designed for a wide variety of applications. Spare parts stocking is cut to minimum through high interchangeability of manufacture components. The standard casing mounted arrangement feature “BACK PULL-OUT”facility when a spacer coupling is used.

High effifiency volute with self-venting vertical centre line discharge. Wear rings can be fitted as an optional feature. Fully shrouded impeller designed for high suction lift. Hydraulically and statically balanced. Large diameter shaft designed to take full load stresses with minimum defletion. Fully machined and ground sections where fine finishing and imensional tolerances are critical. Six designs of shafts for 45 sizes of pumps.

Standard soft packaed with high quality and fitted with lantern ring to prevent air leakage into pump casing when operationg on suction lift. Shaft sleeve is fitted on to larger pump sizes to prevent direct wear on shaft. Mechanical seals to suit specific service condition are available for leak-free operation. Two identical bearings sized for long running life under maximum load operation. Grease lubrication is standard. Sturdy design to ensure rigidity and viration-free operation. Five design for 45 sizes of pumps.

Applications

1. Chiller & Condenser Pumps         5. Fire Fighting
2. Collong Tower Pumps                     6. Palm Oil / Agriculture
3. Tranfer System                                    7. Hot and Cold Water Circulation
4. Swimming Pool Pumps